New-generation universal handheld programmer. This permits interaction with clonable-algorithm receivers and transmitters and with control units compatible with the EELINK protocol. Possibility of memorizing different lists of receivers. Simplified parameter management. USB interface for connection to the PC.

Serial cable for Proxima-PC connections.

• Control panel for one or two single phase 120V operators up to 0.5 hp (375 W) each.
• This control panel requires the torque setting to be on the operators.
• 4 steps logic with timer to close.
• Adjustable second motor delay on closing.
• Selfdiagnosis through LED.
• Quick wiring through plugin terminal strips.
• Plug-in connector for receiver. UL/CSA approved.

• Control panel for one or two single phase operators up to 0.4 hp (300 W) each.
• 2 and 4 steps logic, adjustable timer to close and rapid closing.
• Second motor closing delay adjustable.
• Programming through dip-switches and trimmers.
• Quick wiring through plug-in terminal strips.
• Plug-in connector for receiver.
• Torque adjustment by voltage selection on the transformer.
• UL/CSA approved.

• Control panel for one or two single-phase 120 V operators up to 0.8 hp (600 W) each.
• Easy programming and diagnosis through LCD display.
• Torque and brakesetting.
• 3 and 4 steps logic with timer to close and hold-to-run control.
• Adjustable delay on opening and on closing.
• Quick wiring through plug-in terminal strips.
• Built-in rolling code receiver and plug-in connector for second receiver.

Pre-wired 16” x 18” (40 x 45 cm) enclosure box with RIGEL 5 120V control board.
Features: 2 loop detector sockets (1 free exit, 1 safety), 1 test button, easy connection for motors and accessories, 2 120V power outlets, surge arrestor lightning protection, individual circuit breakers for control board and power outlets. NEMA 4x rated.

• Control panel for one or two single phase 120 V operators up to 0.5 hp (375 W) each.
• This control panel requires the torque setting to be on the operators.
• 2 and 4 steps logic with timer to close and hold-to-run control.
• Adjustable delay on opening and on closing.
• Self-diagnosis through LED.
• Quick wiring through plug-in terminal strips.
• Plug-in connector for receiver. UL/CSA approved.

Pre-wired 16” x 18” (40 x 45 cm) enclosure box with RIGEL 4 UL/CSA control board.
Features: 2 loop detector sockets (1 free exit, 1 safety), 1 test button, easy connection for motors and accessories, 2 120V power outlets, surge arrestor lightning protection, individual circuit breakers for control board and power outlets. NEMA 4x rated.

• Universal control panel for one or two 24 V motors with 1 wire limit switch for each motor.
• Quick wiring through plug-in terminal strips.
• LCD display for quick programming and easy fault diagnosis.
• Crushing prevention by electronic torque self-adjustment.
• Built-in 63 remotes rolling code receiver.
• Optional serial control management, solenoid electric lock and battery backup.

Circuit board for direct connection of wiegand accessories (such as SELETTO, COMPAS SLIM, etc) to the control units QSC D MA, LIBRA C MA, LIBRA C MV, LIBRA C LX, VENERE D, LEO D MA, LEO MV, RIGEL 5 and ALTAIR P.